Installing Accessories; Installing The Wheel Kit; Required Tools; Wheel Kit Packing List - HP rp7420 Service Manual

3 Installing Accessories

This chapter describes how to install components into the server that are not factory integrated.

Installing the Wheel Kit

Compare the packing list shown in
the wheels.
Table 3-1 Wheel Kit Packing List
Part Number
A6753-04013
A6753-04002
A6753-04003
A6753-04004
A6753-00007
A6753-04001
A6753-04005
A6753-04006
A6753-04007
0515-2478
A6093-44013
Not applicable

Required Tools

The following list provides the installer with the recommended tools to perform the wheel kit
installation.
• Diagonal side cutters
• Safety glasses
• Torx screwdriver with T-15 bit
• Phillips head screwdriver
WARNING!
container. These bands are under tension. When cut, they can spring back and cause serious eye
injury.
To attach the wheels to the server, follow these steps:
1. Cut and remove the polystrap bands securing the HP server to the pallet.
2. Lift the carton top from the cardboard tray resting on the pallet.
3. Remove the bezel kit carton and the top cushions from the pallet
Table 3-1
Description
Wheel Kit consisting of the following components:
Right side caster cover
Left side caster cover
Top cover
Caster cover
Right front caster assembly
Right rear caster assembly
Left front caster assembly
Left rear caster assembly
M4 x 0.7 8mm T15 steel zinc machine screw (used to attach
each caster to the chassis)
Plywood unloading ramp
Phillips head wood screw (used to attach the ramp to the
pallet)
Wear protective glasses while cutting the plastic bands around the shipping
with the contents of the wheel kit before installing
Quantity
1
1
1
1
2
1
1
1
1
4
1
2
(Figure 3-1).
Installing the Wheel Kit 41