Figure 4-9 The ls Command Screen
12. To return to the MP Main Menu, enter ma at the Command Screen.
13. To exit the MP, enter x at the MP main menu.
Accessing the MP Through a Web Browser
Web browser access is an embedded feature of the MP. The web browser enables access to the
server through the LAN port on the core I/O card. You must configure the MP from an ASCII
console.
NOTE:
The MP has a separate LAN port from the system LAN port. It requires a separate LAN
drop, IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, the following information is required:
•
IP address for the MP LAN
•
Subnet mask
•
Gateway address
•
Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, follow these steps:
1.
Connect to the MP using a serial connection.
2.
Configure the MP LAN. See
3.
To enter the Command Menu, enter cm.
4.
To display and set MP remote access, enter sa at the MP:CM> prompt.
60
Cabling and Powering the Server
"Configuring LAN Information For the MP" (page
58).