To remove the top cover, follow these steps:
1.
Loosen the retaining screws securing the cover to the rear of the chassis.
2.
Slide the cover toward the rear of the chassis.
3.
Lift the cover up and away from the chassis.
Replacing the Top Cover
To replace the top cover, follow these steps:
1.
Slide the cover into position. It should easily slide into position. Use a slow, firm pressure
to properly seat the cover.
2.
Tighten the retaining screws to secure the cover to the chassis.
Removing and Replacing a Side Cover
It is necessary to remove and replace one or more of the covers to access the components within
the server chassis.
CAUTION:
follow ESD safety precautions can result in damage to the server.
Figure 6-3 Side Cover Locations
Observe all ESD safety precautions before attempting this procedure. Failure to
Removing and Replacing a Side Cover
87