Accessories; Installing Accessories - HP D5970A - NetServer - LCII User Manual

4 Accessories

Installing Accessories

If you are installing an ISA non-plug-and-play accessory board, follow the
directions in the HP NetServer LC 3 Installation Road Map. If it is not available,
refer to Information Assistant. Refer to "Configuring ISA Non-Plug-and-Play
Board" in this chapter to reserve system resources for the board.
If you are installing additional memory (DIMMs), PCI accessory boards, or SCSI
mass storage devices follow the instructions in the HP NetServer LC 3
Installation Road Map. If it is not available, refer to Information Assistant.
The backplane in the HP NetServer LC 3 has five PCI-only slots and one
combined ISA/PCI slot for accessory boards. They are numbered 1-6 from left to
right, as viewed from the rear of the HP NetServer.
Slot 1 is the combined ISA/PCI slot.
An optional disk array controller board (DAC) may be preinstalled in
Slot 5.
Slot 6 contains a network interface controller board (NIC).
The HP NetServer LC 3 chassis contains three hot-swap mass-storage slots and
one open shelf for installation of an optional hard disk.
Shelf 1 contains a flexible disk drive.
Shelf 2 contains an IDE CD-ROM drive.
Shelf 3 can be used to install either a hard disk drive or another accessory.
The hot-swap subsystem occupies the lower area of the front panel. It can
hold up to three hot-swap disk drive modules.
31