Setting The Dimmer Control; Radio; Listening To Radio - Alpine CDE-W203RI Owner's Manual

Setting the Dimmer Control

1
Press FUNC./SETUP so that the
lights up.
2
Press 6/DIMMER repeatedly to select the DIMMER
mode.
DIMMER-A (Auto mode)
DIMMER-A
DIMMER-A mode:
Decrease the illumination brightness of the unit with the head
lights of the vehicle ON. This mode is useful if you feel the unit's
backlighting is too bright at night.
DIMMER ON mode:
Keep the illumination brightness of the unit dark.
DIMMER OFF mode:
Keep the illumination brightness of the unit bright.
3
Press FUNC./SETUP to activate the normal mode.
The indicator goes out.
• Operate the unit while the
performed for 10 seconds, the
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Remote control sensor
Connectable to Remote Control Interface Box
This unit may be controlled from the vehicle's audio controls.
An optional Alpine Remote Control Interface Box must be
used. For details, contact your Alpine dealer.
8
-EN
indicator
DIMMER ON DIMMER OFF
indicator lights up. If no operation is
indicator goes out.

Radio

Preset buttons
(1 through 3)
BAND/TA
SOURCE/
TUNE/A.ME

Listening to Radio

1
Press SOURCE/ to select TUNER mode.
2
Press BAND/TA repeatedly until the desired radio
band is displayed.
F1 (FM1) F2 (FM2)
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode)
OFF (Manual mode) DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or
continuously.
Preset buttons
(4 through 6)
FUNC./SETUP
F3 (FM3) MW LW F1 (FM1)
SEEK (Local mode)
will change the frequency