Completing the parts replacement
After completing the installation or replacement for all parts, you need to reinstall
the computer cover and reconnect cables. Depending on the parts you installed or
replaced, you might need to confirm the updated information in the Setup Utility
program. Refer to Chapter 6, "Using the Setup Utility," on page 51.
To reinstall the computer cover and reconnect cables to your computer, do the
following:
1. Make sure that all components have been reassembled correctly and that no
2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling
3. Position the computer cover on the chassis so that the rail guides on the bottom
Figure 33. Reinstalling the computer cover
4. If the computer cover is secured with screws, install the screws.
5. If a computer cover lock is installed, lock the computer cover.
6. Reconnect the external cables and power cords to the computer.
118
Hardware Maintenance Manual
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the parts replacement."
tools or loose screws are left inside your computer. See "Locating components"
on page 89 for the locations of the various components in your computer.
the front bezel" on page 92.
of the computer cover engage the rails. Then, slide the computer cover closed
until it snaps into position.