Replacing The Front Audio And Usb Assembly - Lenovo ThinkCentre A58 Hardware Maintenance Manual

Replacing the front audio and USB assembly

This section provides instructions on how to replace the front audio and USB
assembly.
To replace the front audio and USB assembly, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 90.
2. Remove the front bezel. See "Removing and reinstalling the front bezel" on
3. Disconnect the front audio and USB assembly cables from the system board.
4. Note the front audio and USB assembly cables routing and remove the screw
Figure 32. Removing the front audio and USB assembly
5. Remove the front audio and USB assembly.
6. Route the cables for the new front audio and USB assembly through the hole in
7. Install the new front audio and USB assembly into the chassis and secure it
8. Connect the new front audio and USB assembly cables to the system board. See
9. Reinstall the front bezel.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
page 92.
See "Locating parts on the system board" on page 90.
that secures the front audio and USB assembly to the chassis.
the chassis to the system board.
with the screw.
"Locating parts on the system board" on page 90.
Chapter 8. Replacing FRUs - Tamdhu
117