Installing Or Replacing The Secondary Hard Disk Drive - Lenovo ThinkCentre A58 Hardware Maintenance Manual

10. Connect the signal cable and the power cable to the rear of the new hard disk
11. Press down on the metal latch 2 and pivot the drive cage into place, and
Figure 24. Installing the primary hard disk drive

Installing or replacing the secondary hard disk drive

This section provides instructions on how to install or replace the secondary hard
disk drive. Depending on your model type, your computer might come with a
secondary hard disk drive bay for you to install or replace a secondary hard disk
drive by yourself.
9. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
slide the drive cage with the new hard disk drive installed into the chassis.
drive. See "Connecting a SATA drive" on page 115.
then slide it to the front of the computer until it snaps into position.
Note: There are two arrows, one on the primary hard disk drive cage and one
on the upper drive cage. The arrows are aligned when the primary hard
disk drive is in the proper position.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the parts replacement" on
page 118.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Chapter 8. Replacing FRUs - Tamdhu
111