IBM NetVista X40 User Manual page 82

® ®
66
IBM IntelliStation E Pro: User's Guide IntelliStation E Pro Types 6836, 6846
Note: If your computer has a CD-ROM drive installed in bay 1, remove the
signal and power cables from the CD-ROM drive before rotating the
drive cage out of the computer.
5. Rotate the drive cage toward the front of the computer until the drive cage
latch locks on the chassis.
Attention: Do not use the drive cage latch to rotate either drive cage out of
the computer.
6. Touch the static-protective bag containing the drive to any unpainted metal
surface on the computer; then, remove the drive from the bag and place it on
a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Install the drive:
v If you are installing a 5.25-in. drive in bay 2, push the drive in to the bay;
then, use the two screws to attach the drive to the drive cage.
v If you are installing a 3.5-in. drive in bay 2, you must attach the 5.25-in.
conversion kit, supplied with your option, to the 3.5-in. drive.
9. Cable the drive:
v If the drive is an IDE device, plug one connector of the IDE signal cable
into the back of the drive and the other end of the cable into the IDE
connector (IDE1) on the system board. For the location of the IDE
connectors, see "System board internal cable connectors" on page 36.
v
If the drive is a SCSI device, plug one connector of the SCSI signal cable
into the back of the drive and the other end of the cable into the SCSI
adapter.
Note: Make sure to route the cable so that it does not block the air flow to the
rear of the drives or over the microprocessor.
Drive cage
Drive cage
latch