IBM NetVista X40 User Manual page 72

4. The illustrations in this document might differ slightly from your hardware.
Complete the following steps to install a DIMM.
Attention:
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 38.
® ®
56
IBM IntelliStation E Pro: User's Guide IntelliStation E Pro Types 6836, 6846
Utility program. When you restart the computer, the system displays a message
indicating that the memory configuration has changed. Start the
Configuration/Setup Utility program and select Save Settings. See "Chapter 4.
Configuring your computer" on page 27 for more information.
When you handle ESD-sensitive devices, take precautions to avoid
1. Review the safety precautions listed in "Safety information" on page 39.
2. Remove any media (diskettes, CDs, or tapes) from the drives and shut down
your operating system.
3. Turn off the computer and attached devices and disconnect all external cables
and power cords; then, remove the cover (see "Removing the side cover" on
page 45 for details).
4. Remove the support bracket assembly and disconnect the fan cable from the
connector (SYSFA3) on the system board. See "Removing the support bracket
assembly" on page 46 for removal instructions.
5. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the computer. Then, remove the DIMM from the package.
6. Install the DIMM:
7.
a. If you are installing a DIMM in connector 1, remove the AGP adapter.
Remove the AGP adapter only if you are replacing the DIMM in connector
1. See "System and PCI extender board option connectors" on page 35 for
the location of the AGP slot. See "Installing an adapter" on page 48 for
details about removing the AGP adapter.
DIMM connector 1
DIMM connector 2
DIMM connector 3
Retaining clip