IBM NetVista X40 User Manual page 69

Statement 3
Danger
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the
following. Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
6. Touch the static-protective bag containing the drive to any unpainted metal
surface on the computer; then, remove the drive from the bag and place it on
a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
8. Install the drive:
v If you are installing a 5.25-in. drive in bay 2, push the drive into the bay.
Then, use the two screws that come with your option to attach the drive to
the drive cage.
v If you are installing a 3.5-in. drive in bay 2, you must attach the 5.25-in.
conversion kit, supplied with your option, to the 3.5-in. drive.
Note: You can install only a 3.5-in. device in bay 4.
9. Cable the drive:
v If the drive is an IDE device, plug one connector of the IDE signal cable
into the back of the drive and the other end of the cable into the IDE
connector (IDE1) on the system board. For the location of the IDE
connectors, see "System board internal cable connectors" on page 36.
EMC shield
Filler panel
Chapter 5. Installing options
53