Water Connection - Bosch WVT 52458 Operating & Installation Instructions Manual

Operating Instructions
G 1 /2
Plastic connector
CS code 424387
Water tap
CS code 184611

Water connection

Water supply
For the water connection a standard cold-water line with a
minimum water pressure of 0.1MPa is required (with tap full
ON, at least 8 litres of water must flow out in one minute). If
the water pressure exceeds 1MPa, a pressure reducing valve
must be added.
Never connect the machine to the mixer tap of a pressure-
less hot-water heater.
Caution! Connections are under full water pressure,
check for leaks with tap turned fully ON.
The filters at the free end of the inlet hose and at the back
of machine should only be removed for cleaning purposes.
To avoid water damage, the tap must be turned OFF after
using the machine.
The plastic nuts on the hose connections must only be
tightened by hand.
For tight connection between washer-dryer and water
source, you can:
1. Call Customer Service before you install the machine,
get the plastic connector freely. It may connect tightly the
water inlet pipe and your water tap.
2. Or you may purchase the specific water tap from custo-
mer service. It is designed by factory. It may be better co-
nnected with machine than your water tap.
Note: The water tap is not free.
Caution:
Do not disassemble the water inlet hose frequently, the
untight connection will lead to leakage. We suggest that
you use a water inlet hose specially for the washer-dryer.
If you need lengthen the water inlet hose together with the
machine, please contact local ASS center/station or leader
to buy additional lengthening hose.
Additional lengthening water inlet hose is not free.
39