Bosch WVT 52458 Operating & Installation Instructions Manual page 33

Operating Instructions
Draining the
washing solution
2.
£¡
R isk of Scalding
Allow the hot washing solution to cool.
Turn the programme selector to Off .
Fold down the cover panel. Fold down the cover panel.
1.
Carefully remove the pump cap. But do not fully remove it
and allow a little more residual water flow into the suitable
container.
Remove the pump cap.
Remove any loose debris/fluff from inside the pump and
clean the pump. The pump impeller must be able to rotate.
Clean any residual suds or fluff from the thread of the
pump cap and pump housing.
Attach and tighten the pump cap.
Attach and close the cover plate.
To avoid unused detergent from flowing into the
drain during the next wash cycle:
Pour 1 litre of water into chamber II
Select the Draining programme.
Cleaning water inlet strainers
This necessary if very little or no water flows into the washing
machine.
First release the water pressure in the supply hose:
Turn of the water tap.
Turn the programme selector to any programme.
(Except
Press the Start button, and allow the programme to run
for approx.40 seconds.
,,
,,
,,
,, ,,
Spinning and Draining )
,,
,,
,,
,,
,,
31