Removing The Transport Bolts - Bosch WVT 52458 Operating & Installation Instructions Manual

Operating Instructions
Installation location
To ensure the proper operation of the washer-dryer, please
pay attention to the following when you install the machine.
The floor should be solid and flat, never put the machine
on the soft carpet or on the wood floor.
Keep the environment dry and vented.
Never put small appliance, such as microwave oven; and/
or jar cooker, on the machine.
Keep the machine away from the flaming equipment, such
as candle, cooking stove, liquefied gas container etc.
Never put the pressure containers on the machine.
Never put the machine over the opening of uncovered
drainage.
In the case of suspended wooden floors, place the machi-
ne on a water-resistant wooden board (plinth ) of at least
30mm thicknees which is screwed to the floor. If possible,
install the machine in a corner of the room. Secure the
,
machine s feet with brackets (this applies partcularly to
tower arrangements).
If the machine is installed on a plinth, the machine s feet
must be secured with brackets to prevent it sliding when
spinning.

Removing the transport bolts

The transport bolts must always be removed before using the
appliance for the first time and must be retained for any sub-
sequent transport (e.g. When moving)
Use the spanner provided only if a ring spanner is unavailable.
Loosen all four transit bolts with the wrench until they are Loosen all four transit bolts with the wrench until they are
freely movable. freely movable.
If not all parts have been removed and have falled into the
button of the washer-dryer: open the door, pull the drum
forwards slightly, reach in and remove the parts.
A A
B B
37
,