Radio; Listening To Radio; Manual Storing Of Station Presets; Automatic Memory Of Station Presets - Alpine CDA-9811R Owner's Manual

Radio

SOURCE/ TUNE/ BAND/
POWER A.ME TEL.
g f SEARCH

Listening to Radio

1
Press SOURCE/POWER until a radio frequency
appears in the display.
2
Press BAND/TEL. repeatedly until the desired
radio band is displayed.
FM1 (F1) → FM2 (F2) → FM3 (F3) → MW → LW → FM1 (F1)
3
Press TUNE/A.ME to select the tuning mode.
CDA-9815RB:
DX SEEK (Distance mode) → SEEK (Local mode) →
OFF (Manual mode) → DX SEEK
CDA-9813R/CDA-9812RX:
DX SEEK (Distance mode) → DX SEEK (Local mode) →
DX SEEK (Manual mode) → DX SEEK
CDA-9811R:
DX SEEK (Distance mode) → DX SEEK (Local mode) →
DX SEEK(Manual mode)→ DX SEEK
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press g or f to tune in the desired station.
Holding down g or f will change the frequency
continuously.
• The ST indicator appears on the display when a stereo FM station
is tuned in.
8
-EN
Rotary encoder
F/SETUP Preset buttons
(1 through 6)

Manual Storing of Station Presets

1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press and hold any one of the preset buttons
(1 through 6) that you want to store the station
on for at least 2 seconds.
The selected station is stored.
The display shows the band, preset no. and station
frequency memorized.
• A total of 30 stations can be stored in the preset memory (6 stations
for each band; FM1, FM2, FM3, MW and LW).
• If you store a station in a preset memory which already has a
station, the current station will be cleared and replaced with the
new station.
• If the "FUNC" indicator (only the underlined portion of the
"FUNC" indicator for CDA-9811R) is illuminated, turn off the
indicator by pressing F/SETUP, then you can perform the
operation.

Automatic Memory of Station Presets

1
Press BAND/TEL. repeatedly until the desired
radio band is displayed.
2
Press and hold TUNE/A.ME for at least 2 seconds.
The frequency on the display continues to change while
the automatic memory is in progress. The tuner will
automatically seek and store 6 strong stations in the
selected band. They will be stored into buttons 1 to 6 in
order of signal strength.
When the automatic memory has been completed, the
tuner goes to the station stored in preset location no. 1.
• If no stations are stored, the tuner will return to the original station
you were listening to before the auto memory procedure began.

Tuning to Preset Stations

1
Press BAND/TEL. repeatedly until the desired
band is displayed.
2
Press any one of the station preset buttons (1
through 6) that has your desired radio station in
memory.
The display shows the band, preset number and
frequency of the station selected.
• If the "FUNC" indicator (only the underlined portion of the
"FUNC" indicator for CDA-9811R) is illuminated, turn off the
indicator by pressing F/SETUP, then you can perform the
operation.