Remote Control; Controls On Remote Control (Cda-9815Rb/ Cda-9813R/Cda-9812Rx Only); Operating The Audio Processor (Cda-9815Rb/Cda-9813R Only) - Alpine CDA-9811R Owner's Manual

Remote Control

1
2
3
4
Controls on Remote Control (CDA-9815RB/
CDA-9813R/CDA-9812RX only)
1 Power Button
Press this button to turn the power on/off.
2 Source Button
Press this button to select the audio source.
3 -/J Button
Press this button to switch between the Play and Pause
modes for CD.
4 TILT 98 Buttons
Press this button to adjust the angle of the movable
display.
5 Band/Programme Button
Radio mode: BAND Button
Press this button and the band will change.
CD/Changer mode: To switch the disc mode.
6 Volume Adjustment Buttons
To increase the volume level:
Press the L button
To decrease the volume level:
Press the K button
7 8 Button
Radio mode: Pressing this button will select, in ascending
order, stations programmed into the radio's presets as
shown below.
1 → 2 ... 6 → 1
CD Changer mode: DISC Select (UP) button
Press this button to select a disc in ascending order.
MP3/WMA mode: Press the Folder Select (UP) button to
select the folder.
8 g DN Button
Radio mode: SEEK (DN) Button
CD mode: Press this button to go back to the beginning of
the current track.
36
-EN
9 f UP Button
! 9 Button
5
6
7
8
9
!
"
" Mute Button
#
# Audio Processor Button*
* 1
2
*
Operating the Audio Processor
(CDA-9815RB/CDA-9813R only)
1
2
Radio mode: SEEK (UP) button
CD mode: Press this button to advance to the beginning
of the next track.
Radio mode: Pressing this button will select, in
descending order, stations programmed into the radio's
presets as shown below.
6 → 5 ... 1 → 6
CD Changer mode: DISC Select (DN) button
Press this button to select a disc in descending order.
MP3/WMA mode: Press the Folder Select (DN) button to
select the folder.
Press this button to lower the volume by 20 dB instantly.
Press this button again to cancel.
CDA-9815RB/CDA-9813R only
Each press the button to switch the audio processor
mode.
For details, refer to "Operating the Audio Processor" as
shown below.
CDA-9815RB/CDA-9813R/CDA-9812RX
Press the button to call the external audio processor
mode when the external audio processor is connected.*
This button is used for CDA-9812RX in conjunction with an
optional Ai-NET processor.
For the operation of external audio processor, refer to the Owner's
Manual of the external audio processor you purchased.
Press A.PROC to select the mode.
Normal mode → EQ mode (Equalizer Presets) → Private mode
(Recalling the Stored Equalizer Curve) → Time Correction
mode (Recalling the Stored Time Correction) → Crossover
mode (Recalling the Stored Crossover) → Normal mode
Press 8 or 9 to select the mode.
EQ mode
Select from FLAT, POPS, ROCK and NEWS.
Private mode/Time Correction mode/Crossover mode
Select from MEMORY 1 through 6.
1
2