Cisco WS-C3550-12G Software Configuration Manual page 431

Chapter 19 Configuring Network Security with ACLs
This is an example of output from the show access-lists privileged EXEC command, displaying all
standard and extended ACLs:
Switch# show access-lists
Standard IP access list 1
permit 172.20.10.10
Standard IP access list 10
permit 12.12.12.12
Standard IP access list 12
deny
Standard IP access list 32
permit 172.20.20.20
Standard IP access list 34
permit 10.24.35.56
permit 23.45.56.34
Extended IP access list 120
permit eigrp host 12.3.6.5 host 25.36.1.24
Extended MAC access list mac1
This is an example of output from the show ip access-lists privileged EXEC command. It displays only
IP standard and extended ACLs. Note that the named MAC extended ACL displayed in the previous
example is not included in this display.
Switch# show ip access-lists
Standard IP access list 1
permit 172.20.10.10
Standard IP access list 10
permit 12.12.12.12
Standard IP access list 12
deny
Standard IP access list 32
permit 172.20.20.20
Standard IP access list 34
permit 10.24.35.56
permit 23.45.56.34
Extended IP access list 120
permit eigrp host 12.3.6.5 host 25.36.1.24
This example shows how to view all access groups configured for Gigabit Ethernet interface 0/2, which
has IP enabled:
Switch# show ip interface gigabitethernet0/2
GigabitEthernet0/2 is up, line protocol is down
Internet address is 10.20.30.1/16
Broadcast address is 255.255.255.255
Address determined by setup command
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is permit Any
Inbound
<output truncated>
78-11194-03
1.3.3.2
1.3.3.2
access list is 13
Catalyst 3550 Multilayer Switch Software Configuration Guide
Configuring Router ACLs
19-21