Cisco WS-C3550-12G Software Configuration Manual page 319

Chapter 11 Configuring IGMP Snooping and MVR
Figure 11-1 Initial IGMP Join Message
Forwarding
Router A sends a general query to the switch, which forwards the query to ports 2 through 5, all members
of the same VLAN. Host 1 wants to join multicast group 224.1.2.3 and multicasts an IGMP membership
report (IGMP join message) to the group with the equivalent MAC destination address of
0x0100.5E01.0203. When the CPU receives the IGMP report multicast by Host 1, the CPU uses the
information in the IGMP report to set up a forwarding-table entry, as shown in
the port numbers of Host 1, the router, and the switch internal CPU.
Table 11-1 IGMP Snooping Forwarding Table
Destination Address
0100.5exx.xxxx
0100.5e01.0203
Note that the switch hardware can distinguish IGMP information packets from other packets for the
multicast group.
• The first entry in the table tells the switching engine to send IGMP packets to only the switch CPU.
This prevents the CPU from becoming overloaded with multicast frames.
• The second entry tells the switching engine to send frames addressed to the 0x0100.5E01.0203
multicast MAC address that are not IGMP packets (!IGMP) to the router and to the host that has
joined the group.
If another host (for example, Host 4) sends an unsolicited IGMP join message for the same group
(Figure
as shown in
the message is not flooded to other ports on the switch. Any multicast traffic is forwarded to the group
and not to the CPU.
78-11194-03
Switching engine
CPU
0
table
2 3
Host 1 Host 2
Type of Packet
IGMP
!IGMP
11-2), the CPU receives that message and adds the port number of Host 4 to the forwarding table
Table 11-2. Note that because the forwarding table directs IGMP messages to only the CPU,
Router A
1
IGMP report 224.1.2.3
VLAN
4 5
Host 3 Host 4
Ports
0
1, 2
Catalyst 3550 Multilayer Switch Software Configuration Guide
Understanding IGMP Snooping
Table 11-1, that includes
11-3