Stp Interface States - Cisco WS-C3550-12G Software Configuration Manual

Multilayer switch
Hide thumbs Also See for WS-C3550-12G:
Table of Contents

Advertisement

Understanding Basic STP Features

STP Interface States

Propagation delays can occur when protocol information passes through a switched LAN. As a result,
topology changes can take place at different times and at different places in a switched network. When
a Layer 2 interface transitions directly from nonparticipation in the spanning-tree topology to the
forwarding state, it can create temporary data loops. Interfaces must wait for new topology information
to propagate through the switched LAN before starting to forward frames. They must allow the frame
lifetime to expire for forwarded frames that have used the old topology.
Each Layer 2 interface on a switch using STP exists in one of these states:
A Layer 2 interface moves through these states:
Figure 10-2
Figure 10-2 Spanning Tree Layer 2 Interface States
Power-on
initialization
Blocking
Listening
Learning
Forwarding
When you power up the switch, STP is enabled by default, and every interface in the switch, VLAN, or
network goes through the blocking state and the transitory states of listening and learning. Spanning tree
stabilizes each Layer 2 interface at the forwarding or blocking state.
Catalyst 3550 Multilayer Switch Software Configuration Guide
10-6
Blocking—The Layer 2 interface does not participate in frame forwarding.
Listening—the first transitional state after the blocking state when STP determines that the Layer 2
interface should participate in frame forwarding.
Learning—The Layer 2 interface prepares to participate in frame forwarding.
Forwarding—The Layer 2 interface forwards frames.
Disabled—The Layer 2 interface is not participating in STP because of a shutdown port, no link on
the port, or no spanning-tree instance running on the port.
From initialization to blocking
From blocking to listening or to disabled
From listening to learning or to disabled
From learning to forwarding or to disabled
From forwarding to disabled
illustrates how a Layer 2 interface moves through the states.
state
Disabled
state
state
state
state
Chapter 10
Configuring STP
78-11194-03

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3550

Table of Contents