IBM 6648 - NetVista A40 - 128 MB RAM User Manual page 56

to Enabled, your computer will turn on when it receives a specific signal
from another computer on your local area network (LAN).
v Wake on Alarm: With this feature, you can specify a date and time at which
the computer will be turned on automatically. This can be either a single
event, a daily event, or a weekly event.
v PCI Wake Up: If this setting is enabled, your computer turns on in response
to wake up requests from PCI devices that support this feature.
To set automatic power-on features, follow these steps:
1. Start the Configuration/Setup Utility program (see "Starting and using the
Configuration/Setup Utility program" on page 29).
2. Select Power Management and press Enter.
3. Select Automatic Power On and press Enter.
4. Select the menu item for the feature you want to set. Use Left Arrow ( ) or
Right Arrow ( ) to select either Enabled or Disabled. Press Enter.
5. Select Startup Sequence for the feature. Use Left Arrow ( ) or Right Arrow
( ) to select either Primary or Automatic. If you select Automatic, make
sure Automatic Power On Startup Sequence in the Startup Sequence menu
is set to Enabled. Otherwise, the system will use the Primary startup
sequence.
6. Press Esc until you return to the Configuration/Setup Utility program
menu.
7. Select Save Settings from the Configuration/Setup Utility program menu
and press Enter. Then press Esc and follow the instructions on the screen to
exit from the Configuration/Setup Utility program.
42
User Guide