Electronic Emissions Notices; Class B Notices; Federal Communications Commission (Fcc) Statement - IBM 6648 - NetVista A40 - 128 MB RAM User Manual

Electronic emissions notices

This computer is classified as a Class B digital device. However, this computer
includes a built-in network interface controller (NIC) and is considered a Class
A digital device when the NIC is in use. Additionally, NetVista A20 Type 6269
computers are considered Class A digital digital devices when a second dual
inline memory module (DIMM) is installed. The Class A digital device rating
and compliance notice are primarily because the inclusion of certain Class A
options or Class A NIC cables changes the overall rating of the computer to
Class A.
Cet ordinateur est enregistré comme un appareil numérique de classe B.
Toutefois, lorsque la carte réseau qu'il contient est utilisée, il est considéré
comme un appareil de classe A. Il a été déclaré de classe A dans l'avis de
conformité car la présence de certaines options de classe A ou de câbles de
carte réseau de classe A modifie ses caractérisques et le rend conforme aux
normes de la classe A.

Class B notices

NetVista A20 Type 6269, NetVista A40 Types 6568, 6578, and 6648, NetVista
A40p Types 6569, 6579, and 6649

Federal Communications Commission (FCC) statement

Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
v Reorient or relocate the receiving antenna.
v Increase the separation between the equipment and receiver.
v Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
v Consult an IBM authorized dealer or service representative for help.
Properly shielded and grounded cables and connectors must be used in order
to meet FCC emission limits. Proper cables and connectors are available from
IBM authorized dealers. IBM is not responsible for any radio or television
interference caused by using other than recommended cables and connectors or
123
Appendix E. Notices and trademarks