Installing An Ism - Cisco WS-C2950-24 Installation Manual

Installing and Removing ISMs
Replace the chassis cover. For Cisco 2900 series, see the
Step 7
section on page
Engine" section on page

Installing an ISM

To install an ISM, use a number 2 Phillips screwdriver or flat-blade screw drive, and a 1/4-inch nut driver
or wrench. Cisco 2900 and Cisco 3900 series routers have one ISM connector on the system board.
Read the
Step 1
any module replacement.
Access the ISM slot. For Cisco 2900 series, see the
Step 2
section on page
Engine" section on page
Locate the four standoffs from the accessory kit. See
Step 3
Figure 5-13
Step 4 Install the four standoffs into the system board in the attachment locations, as shown in
a 1/4-inch nut driver to tighten the standoffs. The locations for ISM standoffs have white plastic
grommets surrounding the mounting hole location.
Cisco 2900 Series and 3900 Series Hardware Installation Guide
5-18
5-4. For Cisco 3900 series, see the
5-6.
"Safety Warnings" section on page 5-2
5-4. For Cisco 3900 series, see the
5-6.
Standoffs
Chapter 5 Installing and Upgrading Internal Modules and FRUs
"Removing and Replacing the Chassis Cover"
"Removing and Replacing the Services Performance
and disconnect the power supply before you perform
"Removing and Replacing the Chassis Cover"
"Removing and Replacing the Services Performance
Figure 5-13.
Figure 5-14. Use
OL-18712-03