Connecting To The Auxiliary Port - Cisco WS-C2950-24 Installation Manual

Chapter 3 Installing and Connecting the Router
Disconnect the router console terminal before uninstalling the driver.
Note
Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 1
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 2
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 3
When the Remove the Program window appears, click Remove.
Step 4
If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.
Note
When the InstallShield Wizard Completed window appears click Finish.
Step 5

Connecting to the Auxiliary Port

When a modem is connected to the auxiliary port, a remote user can dial in to the router and configure
it. Use the light blue console cable and the DB-9-to-DB-25 connector adapter that came in the router
accessory kit.
To connect a modem to the router, follow these steps:
Connect the RJ-45 end of the adapter cable to the black AUX port on the router. (See
Step 1
Figure
OL-18712-01
3-39, or Figure 3-40.)
Connecting to the Auxiliary Port
Cisco 2900 and 3900 Series Hardware Installation
Figure 3-38,
3-39