Powering Up The Router; Checklist For Power Up - Cisco WS-C2950-24 Installation Manual

Configuring the Router
This document describes how to power up the router and perform the initial configuration in the
following sections:
•
•
•

Powering up the Router

Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
This section covers the following topics:
•
•
•
•

Checklist for Power Up

Check the following items before powering up the router:
•
•
•
OL-18712-01
Powering up the Router, page 4-1
Performing the Initial Configuration on the Router, page 4-4
Using Cisco Setup Command Facility, page 4-4
-
Using Cisco Configuration Professional Express, page 4-8
-
Using Cisco IOS CLI-Manual Configuration, page 4-8
-
Verifying the Initial Configuration, page 4-24
Powering up the Router, page 4-1
Performing the Initial Configuration on the Router, page 4-4
Verifying Network Connectivity, page 4-21
Verifying the Initial Configuration, page 4-24
Chassis is securely mounted and grounded.
Power and interface cables are connected.
The external CompactFlash memory card is properly seated into its slot. For installation
instructions, see "Removing and Installing CompactFlash Memory Cards" procedure on page
C H A P T E R
Cisco 2900 and 3900 Series Hardware Installation
4
5-52.
4-1