Advertisement
Ribbon installation - Hold the ribbon cartridge over the ribbon compartment with the exposed ribbon facing
toward you. Tilt the left side of the cartridge down and position the ribbon along the left side of the printer.
Gently move the ribbon cartridge down and press it into the ribbon compartment until you hear it click into
place. Be sure that the ribbon is next to the edge of the printhead as shown on the inside of the roll door.
Tighten the ribbon by advancing the turn knob in a clockwise directions.
Troubleshooting & Frequently Asked Questions
Q. How many part numbers can you use with the I.D. PRO Plus wire marker printer?
A. Over 166 label/sleeve combinations.
Q. Are we going to make custom labels for the I.D. PRO Plus wire marker printer?
A. Yes. Treat like BMXC, check for same size.
Q. How do you do simple serialization?
A. 1. Press the SHIFT-SERIAL key combination.
2. Enter a number from 1 to 99.
3. Press ENTER or PRINT to print or press CLEAR to cancel.
Q. What are the text sizes available on the I.D. PRO Plus?
A. Large text: 8 cpi (0.125 height)
Small text: 12 cpi (0.094 height)
Q. What are the main advantages of the I.D. PRO Plus wire marker printer?
A. 1. 43 percent faster
2. Availability of bold printing
3. Serialization capability
4. Up to 8 lines of different text
Q. How do I respond when the customer indicates that the I.D. PRO Plus is printing off centered?
A. Find out what material the customer is using and change the size code.
Q. Compare the life span of the ribbon when using bold printing versus normal printing?
A. Approximately 16,000 characters with bold type versus approx. 20,000 characters of normal type.
Q. When purchasing the I.D. PRO Plus wire marker printer what can I expect to receive?
A. Printer
Batter pack
Wrist Code
Page 9
Advertisement
