Brady BRADYMARKER XC Plus Manual page 7

Paper shoot & material guide assembly
This is a three piece mechanical assembly through which the material (labels) pass before being
printed. This section can be taken apart for easy removal of labels that may have gotten stuck
in the unit.
Optic eye
The optic eye is the material sensing device on the BMXC's. It senses the "cut-out" on the
material to align the marker for proper print positioning.
Ribbon
The BMXC+ uses the R2200 ribbon. The BMXC+-PS uses the R5200 ribbon.
Battery pack
The battery pack must be charged for 16 hours with the AC adapter/charger prior to usage for
optimal performance. To ensure proper charging, the barrel plug must be fully inserted inside
the power jack. Only the molded housing should be visible. The battery pack will last through
2-3 years of chargings. A fully charged unit should last through a few days of continual usage.
Any nicad battery should be run until the "battery low" warning is displayed before recharging
.
Page 7