Plustek NVR 4200V User Manual page 16

NVR 4200V
To set up the NVR system in your LAN environment:
Please configure the IP address of the IP cameras before
connecting to the NVR.
Attention
1. Put the cable clasp onto the RJ-45 cables. Put that end of the cable
connectors through the cable stabilizer rack. Clasp the cable clasp into the
cable stabilizer rack.
2. Plug the RJ-45 connectors into LAN port of NVR and IP camera RJ-45 port.
3. Plug the RJ-45 connectors into WAN port and Router's LAN port.
4. Fasten the rack screws to fix the cable stabilizer rack on the rear panel of the
NVR.
12