Sample Rcp Download Procedures - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 33 Working with System Software Images
Step 4 Modify the BOOT environment variable by entering the set boot system flash device:filename prepend
command, so that the new image boots when you reset the switch. Specify the Flash device (device:) and
the filename of the downloaded image (filename).
Reset the switch by entering the reset system command. If you are connected to the switch through
Step 5
Telnet, your Telnet session disconnects.
During startup, the Flash memory on the supervisor engine is reprogrammed with the new Flash code.
When the switch reboots, enter the show version command to check the version of the code on the
Step 6
switch.

Sample rcp Download Procedures

This example shows a complete rcp download procedure of a supervisor engine software image:
Console> (enable) show version 1
Mod Port Model
--- ---- ---------- --------- ----------------------------------------
1
Console> (enable) copy rcp flash
IP address or name of remote host []? 172.20.52.3
Name of file to copy from []? cat4000.6-1-1.bin
Flash device [bootflash]?
Name of file to copy to [cat6000.6-1-1.bin]?
4369664 bytes available on device bootflash, proceed (y/n) [n]? y
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCC
File has been copied successfully.
Console> (enable) set boot system flash bootflash:cat4000.6-1-1.bin prepend
BOOT variable = bootflash:cat4000.6-1-1.bin,1;bootflash:cat4000.5-1-2.bin,1;
Console> (enable) reset system
This command will reset the system.
Do you want to continue (y/n) [n]? y
Console> (enable) 07/21/2000,13:51:39:SYS-5:System reset from Console//
System Bootstrap, Version 3.1(2)
Copyright (c) 1994-1997 by cisco Systems, Inc.
Presto processor with 32768 Kbytes of main memory
Autoboot executing command: "boot bootflash:cat4000.6-1-1.bin"
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCC
Uncompressing file:
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
################################################################################
#############
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Serial #
2 WS-X5530 007451586 Hw : 1.3
###########################################################
Downloading System Software Images to the Switch Using rcp
Versions
Fw : 3.1.2
Fw1: 3.1(2)
Sw : 4.1(2)
33-7