Cisco WS-C2948G-GE-TX Configuration Manual page 467

Chapter 30 Configuring Switch Access Using AAA
To enable TACACS+ directed request, perform this task in privileged mode:
Task
Step 1
Enable TACACS+ directed request on the switch. set tacacs directedrequest enable
Step 2
Verify the TACACS+ configuration.
This example shows how to enable TACACS+ directed request and verify the configuration:
Console> (enable) set tacacs directedrequest enable
Tacacs direct request has been enabled.
Console> (enable) show tacacs
Tacacs key: Secret_TACACS_key
Tacacs login attempts: 5
Tacacs timeout: 30 seconds
Tacacs direct request: enabled
Tacacs-Server
----------------------------------------
172.20.52.3
172.20.52.2
172.20.52.10
Console> (enable)
Disabling TACACS+ Directed Request
To disable TACACS+ directed request, perform this task in privileged mode:
Task
Step 1
Disable TACACS+ directed request on the switch. set tacacs directedrequest disable
Step 2 Verify the TACACS+ configuration.
This example shows how to disable TACACS+ directed request:
Console> (enable) set tacacs directedrequest disable
Tacacs direct request has been disabled.
Console> (enable)
Clearing TACACS+ Servers
To clear one or more TACACS+ servers, perform this task in privileged mode:
Task
Step 1 Specify the IP address of the TACACS+ server to
clear from the configuration. Use the all keyword
to clear all of the servers from the configuration.
Step 2 Verify the TACACS+ server configuration.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Command
show tacacs
Status
-------
primary
Command
show tacacs
Command
clear tacacs server [ip_addr | all]
show tacacs
Configuring Authentication
30-21