Cisco WS-C2948G-GE-TX Configuration Manual page 474

Configuring Authentication
----------------------------- -------
172.20.52.3
172.20.52.2
Console> (enable)
Specifying Optional Attributes for RADIUS Servers
You can specify optional attributes in the RADIUS ACCESS_REQUEST packet. The set radius
attribute command allows you to specify the transmission of certain optional attributes such as
Framed-IP address, NAS-Port, Called-Station-Id, and Calling-Station-Id. You can set the attribute
transmission by either the attribute number or the attribute name. Transmission of the attributes is
disabled by default.
Note Software release 7.5(1) supports only the framed-IP address (Attribute 8).
To specify optional attributes for the RADIUS server, perform this task in privileged mode:
Task
Step 1
Specify optional attributes for the RADIUS
server.
Step 2
Verify the RADIUS configuration.
This example shows how to specify and enable the framed-IP address attribute by number:
Console> (enable) set radius attribute 8 include-in-access-req enable
Transmission of Framed-ip address in access-request packet is enabled.
Console> (enable) show radius
RADIUS Deadtime:
RADIUS Key:
RADIUS Retransmit:
RADIUS Timeout:
Framed-Ip Address Transmit:
RADIUS-Server
----------------------------- -------
10.6.140.230
Console> (enable)
This example shows how to specify and disable the framed-IP address attribute by name:
Console> (enable) set radius attribute framed-ip-address include-in-access-req disable
Transmission of Framed-ip address in access-request packet is disabled.
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
30-28
------------
primary 1812
1812
Command
set radius attribute [number | name]
include-in-access-req [enable | disable]
show radius
0 minutes
123456
2
5 seconds
Enabled
Status Auth-port
------------
primary 1812
Chapter 30 Configuring Switch Access Using AAA
Acct-port
------------
1813
78-15908-01