Cisco WS-C2948G-GE-TX Configuration Manual page 472

Configuring Authentication
To set the RADIUS timeout interval, perform this task in privileged mode:
Task
Step 1
Set the RADIUS timeout interval.
Step 2
Verify the RADIUS configuration.
This example shows how to set the RADIUS timeout interval and verify the configuration:
Console> (enable) set radius timeout 10
Radius timeout set to 10 seconds.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Enable Authentication: Console Session
---------------------- ----------------- ----------------
tacacs
radius
local
Radius Deadtime:
Radius Key:
Radius Retransmit:
Radius Timeout:
Radius-Server
----------------------------- -------
172.20.52.3
Console> (enable)
Setting the RADIUS Retransmit Count
You can set the number of times the switch will attempt to contact a RADIUS server before the next
configured server is tried. By default, each RADIUS server will be tried two times.
To set the RADIUS retransmit count, perform this task in privileged mode:
Task
Step 1
Set the RADIUS server retransmit count.
Step 2
Verify the RADIUS configuration.
This example shows how to set the RADIUS retransmit count as 4 and how to verify the configuration:
Console> (enable) set radius retransmit 4
Radius retransmit count set to 4.
Console> (enable) show radius
Login Authentication:
---------------------
tacacs
radius
local
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
30-26
Command
set radius timeout seconds
show radius
Console Session Telnet Session
---------------- ----------------
disabled disabled
enabled(primary) enabled(primary)
enabled enabled
Telnet Session
disabled disabled
enabled(primary) enabled(primary)
enabled enabled
0 minutes
Secret_RADIUS_key
2
10 seconds
Status Auth-port
------------
primary 1812
Command
set radius retransmit count
show radius
Console Session Telnet Session
---------------- ----------------
disabled disabled
enabled(primary) enabled(primary)
enabled enabled
Chapter 30 Configuring Switch Access Using AAA
78-15908-01