Disabling The Ip Permit List; Clearing An Ip Permit List Entry - Cisco WS-C2948G-GE-TX Configuration Manual

Configuring the IP Permit List on the Switch
172.100.101.104
172.187.206.222
Console> (enable) show snmp
RMON:
Extended RMON Netflow:
Traps Enabled:
ippermit
Port Traps Enabled: None
Community-Access
----------------
read-only
read-write
read-write-all
Trap-Rec-Address
----------------------------------------
Console> (enable)

Disabling the IP Permit List

To disable the IP permit list on the switch, perform this task in privileged mode:
Task
Step 1 Disable the IP permit list.
Step 2 Verify the IP permit list configuration.
This example shows how to disable the IP permit list:
Console> (enable) set ip permit disable
IP permit list disabled.
Console> (enable)

Clearing an IP Permit List Entry

You can clear an IP address from the SNMP permit list, Secure Shell (SSH) permit list, the Telnet permit
list, or all lists. If you do not specify which permit list to clear the IP address from, the IP address is
deleted from both permit lists.
Disable the IP permit list before clearing IP permit entries or host addresses. This action prevents your
Caution
connection from being dropped by the switch that you are configuring in case you clear your current IP
address.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
18-4
01/20/97,07:45:20 SNMP
01/21/97,14:23:05 Telnet
Disabled
Disabled
Community-String
--------------------
public
private
secret
Chapter 18
14
7
Trap-Rec-Community
--------------------
Command
set ip permit disable [ssh | snmp | telnet]
show ip permit
Configuring the IP Permit List
1430
236
78-15908-01