Table of Contents
Advertisement
CLEANING THE PRINTER
CAUTION:
Do not clean the inside of the printer and do not use stain removers, acetone-based products, liquid or
aerosol cleaners. Doing so could damage the printer case and scanner glass.
1
Clean the printer casing using a soft dry cloth, or one moistened with warm water, to wipe dust, dirt or smears off
the outer case of the printer only.
2
Clean gently the white underside of the scanner glass cover with a soft dry cloth, or one moistened with warm
water.
3
Clean the scanner glass with a soft cloth moistened with warm water or with a glass cleaning solution.
CLEANING THE INK CARTRIDGE NOZZLES
Clean the nozzles when:
•
White or colour lines appear on the printouts.
•
Colours are faded, or do not print in parts or at all.
•
Vertical lines in printout are jagged.
To clean the nozzles:
1
Make sure the printer is loaded with A4 paper. See "Loading Documents onto the Automatic Document Feeder".
2
Open the Toolbox application from the Olivetti icon in the task bar, or select Start > Programs or All programs >
Olivetti > Olivetti Toolbox. The main screen of the Toolbox application is displayed.
3
Select Solutions and Assistance.
4
Select the "Clean and test the nozzles" option
5
Select Print.
The printer automatically cleans the nozzles and prints a test page.
6
At the end, select Close to return to the Toolbox main screen.
TROUBLESHOOTING
Problems When Installing the Printer
Before reading this section:
1
Make sure the printer is properly connected to a working grounded electrical outlet compliant with the
printer's power requirements (100 - 240 Vac, 50 - 60 Hz), and that it is switched on.
2
If the printer is connected to a computer, make sure that both the printer and the computer are switched on.
3
These operating systems are supported: Microsoft Windows 2000 (Service Pack 4 or later), XP (Service Pack 2 or
later) or Vista, also MAC OS X 10.2, OS X 10.3 or OS X 10.4.
Problem
The printer does not switch on.
You have inserted the "Installation"
CD into the computer drive and the
installation program does not start
automatically.
40
Maintenance and Troubleshooting
Possible Reason
•
The power cable is not
connected correctly to the
printer and/or to the electrical
outlet.
•
The electrical outlet is not
working.
•
An operating system
incompatible with the CD
software may be running on the
computer.
Corrective Action
1
Make sure that both ends of the
cable are connected correctly
2
Make sure that the grounded
electrical outlet is working.
1
Use the Windows CD for
Windows 2000/XP/Vista, or the
MAC CD for MAC OS X 10.2,
OS X 10.3 or OS X 10.4.
Advertisement
Table of Contents
