Vsd Assembly Grounding - Nautilus Commercial TreadClimber TC916 Service Manual

mechanIcal ServIce

4.0 - vSD aSSeMbly gRouNDiNg

parts affected:
• Front Trim Cover - P/N: SM17652
• Right Pan Cover - P/N: SM17653
• Right Side Cover - P/N: SM17655
• VSD Assembly, TC916 - P/N: SM17688
• Flat Washer, 1/4 ID x 5/8 OD - P/N: SM22047
• Screw, .250-20 x .75, HX Wash HD -
P/N: SM27594
tools needed:
• 1/8 Allen Bit
• 3/8 inch Socket or Open End Wrench
to avoid the risk of electrocution, shock or
mechanical injury, before performing this
maintenance, ensure that the machine is
unplugged.
to Install new vSD Ground Improvement:
4-1:
Adjust Right Treadle to maximum step height.
4-2:
Remove three (3) screws from Front Trim Cover (P/N
- SM17652). See Figure 1.
4-3: Remove four (4) screws from Right Side Cover (P/N
- SM17655). See Figure 2.
4-4:
Remove two (2) screws from Right Pan Cover to access
the VSD Assembly (see Figure 3 and Figure 4).
cautioN: eNSuRe that all lightS aRe off
oN the vSD aSSeMbly befoRe
coNtiNuiNg - otheRwiSe, you May
DaMage the boaRD.
4-5
Disconnect and mark cables (for reconnecting in later step)
from the VSD board.
10
figure 1:
figure 2: