Base Assembly Guide - Nautilus Sport Series Assembly Manual

the following instructions provide direction in assembling the base units for the Nautilus® Sport Series
treadmill models t514, t516 and t518. All instructions in the manual are given with the orientation of standing
on the treadmill facing the console. the console is the front, while the rear roller is the back.
Figure 1: step 1 upright Assembly
Left upright Assembly
Bolt
Washer
Base Assembly
right upright Assembly
2" hex Bolt
1-1/2" hex Bolts
Front Cross support Bracket
Nautilus® Sport Series Treadmill Assembly Manual

bASe ASSembly guide

step 1: Attaching uprights to Base Assembly
Locate the following for this step:
Parts:
• Base assembly
• Left Upright assembly
• right Upright assembly
Hardware:
• 4 Hex Head Bolts (5/16 - #18 x 1-1/2)
• 2 Hex Head Bolts (5/16 - #18 x 2)
• 6 Flat Washers (5/16)
1-1 Place Base assembly in the location you want the
final assembled treadmill.
1-2 Install Left Upright assembly onto Base assembly
using 2 of the 5/16 - #18 x 1-1/2 hex head bolts and
2 flat washers on the front side of the assembly
and 1 hex head bolt (5/16 - #18 x 2) on the outside
of the assembly. hand Tighten Bolts only.