Table of Contents
Advertisement
SAFETY RECOMMENDATIONS
•
Always read the instructions for use
carefully before using your
appliance for the first time:
This product has been designed for
domestic use only. The manufacturer
accepts no responsibility, and the
guarantee will not apply, for any
commercial use, inappropriate use or
failure to comply with the instructions.
•
Do not leave the appliance within reach
of children without supervision. Young
children or severely disabled persons
must always be supervised when using
this appliance.
•
Check that the voltage rating of your
appliance corresponds to that of your
household electrical wiring system.
•
This appliance is manufactured to
conform to the Low Voltage Electrical
Equipment (Safety) Regulations 1989
and is designed to comply with BS
3456. It complies with the requirements
of the EEC Directive (89/336/EEC). Any
connection error will render the
guarantee void.
•
Never leave your appliance to operate
unattended.
•
Unplug your appliance as soon as you
have finished using it (also in the event
of a power cut) and when you are
cleaning it.
•
Never use your appliance if it is not
working correctly or if it has been
damaged. If this happens, contact an
approved Moulinex Service Centre (see
list in service booklet).
•
Do not place the appliance, the power
cable or the plug under running water or
in any other liquid.
•
Do not allow the power cable to hang
down within reach of children.
•
The power cable must never be close to
a heat source or resting on sharp edges.
•
If the power cable or the plug are
damaged, do not use the appliance. To
avoid any risk, these must be replaced
by an approved Moulinex Service Centre
(see list in service booklet).
•
Do not use the appliance for juicing if
the filter holder on the juice extractor
is damaged.
•
For your own safety, use only Moulinex
accessories and spare parts which are
suitable for your appliance.
•
Always use the pushers to push
food down the feeder tubes, never
use your fingers, a fork, a spoon,
a knife or other utensils.
5
•
Only remove the accessories
when the appliance has come to
a complete stop.
•
Do not introduce any utensil (spoon,
spatula...) through the feeder tube.
•
Do not place any utensil containing
metal in a microwave oven.
•
Use the accessories one at a time.
•
Handle the metal blade and
discs with great care: they are
extremely sharp.
•
You must remove the blades (D) and
spindle (C) before emptying the bowl of
its content.
•
Empty the chopping bowl or liquidiser
jug before detaching the handle.
•
Never touch the parts when they
are moving.
•
Do not run your appliance empty.
•
Do not allow long hair, scarves, ties etc.
to dangle over accessories during
operation.
Never use or plug in your appliance if:
•
Its power cord is faulty or damaged.
•
The appliance has been dropped.
•
It has visible damage or operating faults.
In such cases, to avoid any danger,
contact your Approved Service Centre
to have the appliance repaired, as
special tools are required.
Using your appliance
for the fist time
•
Before using for the first time, wash all
accessory parts in warm, soapy water.
Rinse and dry.
•
Place the motor unit on a stable, flat,
clean and dry surface.
•
Plug the appliance in.
•
Speed selector (A5). Choose the setting
required (see table page 4, or recipe).
•
Pulse (intermittent operation): press the
"pulse" button (A9) - using a succession
of pulses can give you better control
when preparing certain foods.
•
Stop: press the "O" button (A7).
•
Before using the liquidiser drive (A2):
ensure that there is no accessory fitted
on the bowl and accessory drive.
ASSEMBLING AND DISMANTLING THE BOWL
1
B3a
B3c
B3b
B4a
FITTING DETACHABLE PARTS
Assembling/Dismantling the bowl
(B3) - (diagram 1)
The bowl can be used with the following
accessories (depending on model):
Blades (D), grating/slicing discs (E),
whisk (F), emulsifying disc (G), citrus
press (H), juice extractor (J).
• If not already in position, fit the rubber
seal (B3c) in the bottom of the bowl.
Ensure that the thin lip of the seal
faces upwards.
• Fit the drive (B3a).
• Fit the nut (B3b) and tighten it to lock
the assembly.
• Dismantle the assembly for cleaning
after each use.
(Note: Whether you are using the Liquidiser jug (l3) or the bowl (B3) you will
need to ensure that the respective handle and lid have been fitted correctly.)
Fitting/Dismantling the bowl
handle (B4) and the liquidiser jug
handle (I4)
For ease of cleaning and storage, the
bowl handle (B4) and liquidiser jug
handle (I4) are detachable.
• To fit the handle, position it against
the lugs of the bowl/jug.
• Slide the handle upwards until
it clicks.
• To detach the handle, press the
release button (B4a) or (I4a) and slide
the handle downwards.
6
Hide quick links:
Advertisement
Table of Contents
