Baby Lock Ellisimo BLSO Instruction And Reference Manual page 53

g
Wind the thread clockwise around the
bobbin 5-6 times.
h
Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread to the right to cut the thread with
the cutter.
a Guide slit (with built-in cutter)
b Bobbin winder seat
CAUTION
• Be sure to follow the process described. If the
thread is not cut with the cutter, and the
bobbin is wound, when the thread runs low it
may tangle around the bobbin and cause the
needle to break.
i
Set the bobbin winding switch to the left,
until it clicks into place.
a Bobbin winding switch
Memo
• Sliding the bobbin winding switch to the left
switches the machine into bobbin winding
mode.
o The bobbin winding window appears.
j
Press .
o Bobbin winding starts automatically. The bobbin
stops rotating when bobbin winding is completed.
The bobbin winding switch will automatically return
to its original position.
Note
• changes to
is winding.
• Stay near the machine while winding the
bobbin to make sure the bobbin thread is
being wound correctly. If the bobbin thread
is wound incorrectly, press
ately to stop the bobbin winding.
• The sound of winding the bobbin with stiff
thread, such as nylon thread for quilting,
may be different from the one produced
when winding normal thread; however, this
is not a sign of a malfunction.
Memo
• You can change the winding speed by
pressing (to decrease) or
increase) in the bobbin winding window.
• Press to minimize the bobbin winding
window. Then, you can perform other
operations, such as selecting a stitch or
adjusting the thread tension, while the
bobbin is being wound.
• Press (in top right of the LCD screen)
to display the bobbin winding window again.
LOWER THREADING
while the bobbin
immedi-
(to
39
1