Pci/Plug And Play Setup - ECS 915PL-A2 User Manual

32
Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the system
can automatically resume at a fixed time based on the system's RTC (realtime clock). Use
the items below this one to set the date and time of the wake-up alarm. You must use an ATX
power supply in order to use this feature.
Keyboard Power On (Disabled)
If you enable this item, system can automatically resume by pressing any keys or power key
or typing in the password on the keyboard. You must use an ATX power supply in order to
usethis feature.
Password (Press Enter)
When Keyboard Power On is set to "Password", this item is available and users can enter the
password.
Press <Esc> to return to the main menu setting page.
PCI / Plug and Play Setup
This page sets up some parameters for devices installed on the PCI bus and those utilizing
the system plug and play capability.
Plug & Play Aware O/S
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
Plug & Play Aware O/S (Yes)
This itme select which, the BIOS or the operating system, will configure all the devices in
the system. If set NO, the BIOS configures the system; set YES, the operating system
configure Plug and Play devices.
Primary Graphics Adapter (PCI-E VGA)
This itme indicates if the primary graphics adapter uses the PCI-E VGA, PCI VGA, or AGP-
E VGA.
Allocate IRQ to PCI VGA (Yes)
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics system. You set this
value to No to free up an IRQ.
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
PCI / Plug and Play Setup
Yes
PCI-E VGA
Yes
Enabled
: Move
+/-/: Value Enter : Select
F8:Best Performance Settings
F9: Optimized Defaults
Using BIOS
Help Menu
No: lets the BIOS
configure all the
devices in the system.
YES: lets the
operating system
configure Plug and
Play (PnP) devices not
required for boot if
your system has a Plug
and Play operating
system.
F1: General help
ESC: Exit
F10: Save