Initial Setup; Osd (On Screen Display); Connection And Operation Of The Osd; Ac Power Cord Connection - Krell Industries S-1200 Owner's Reference Manual

Initial Setup

OSD (On Screen Display)

1. Connection and Operation of the OSD

2. Attach the AC power cord to the receptacle on the back of the S-1200/ 1200U.
3. Plug the Power cord into an AC receptacle and turn on the rear power switch.
4. Connect the Video Output of the S-1200/ 1200U to a Video Monitor
5. Press the Power button on the front panel.
6. Press the Menu Button
16
The OSD (On Screen Display) connection of the S-1200/ 1200U to a video display is the single
most important connection to the setup of this processor. The entire configuration and setup of the
S-1200/ 1200U is performed while viewing the OSD.
Note: Do not connect any inputs at this time.
The S-1200/ 1200U will go through an initialization process and display the current software
revision installed. Wait for the initialization to complete before proceeding.
The OSD can be displayed from any video output. HDMI, component, s-video and composite
video are all supported. Care should be taken in selecting which video format to use. Older
monitors, projectors and televisions do not have the ability to display some of the latest video
output formats. Use composite video if you are uncertain as to the video display's capabilities.
NOTE: When using the HDMI output for OSD do not connect an HDMI input at this time. It can
make initial setup more difficult as the S-1200/ 1200U will be communicating with the source
before the setup of inputs and outputs has occurred.
Within a few seconds the video display will show a blue screen with white text.
NOTE: If you are using an analog output such as component or composite video, press cd on the
front panel, this will go to an analog defaulted video setting and expedite your setup.
NOTE: If a blue screen with text does not occur, check the following:
A. Video connections
B. Input of the video display
C. S-1200/ 1200U is in operation mode
If a problem still persists, turn the S-1200/ 1200U off via the rear panel switch and turn it
back on.
Now that a video connection has been established, press the Menu button, the set-up menu will
appear on the video display. It is now possible to navigate the set-up menu using a combination of
the up, down, left, right, enter, and previous buttons. These can be accessed via the Front panel of
the S-1200/ 1200U or the remote control.
S-1200/ 1200U