VTech CS6449 User Manual page 32

Multiple handset use
Using the telephone base:
Press INT on the telephone base when not in use.
1.
• If you have only one handset, the telephone base
shows Calling HANDSET. The handset rings and
shows Base is calling.
• If you have more than one handset, the telephone
base shows INTERCOM TO: Use the dialing keys
to enter a handset number. The telephone base shows
Calling HANDSET X. The destination handset rings and
shows Base is calling.
2. To answer the intercom call on the destination handset,
/
press
FLASH
#). Both devices now show Intercom.
3. To end the intercom call at the telephone base, press INT
or CANCEL when you are using the base speakerphone, or
return the corded handset to the telephone base. The other party hears four
beeps. Both screens display Intercom ended.
-OR-
To end the intercom call on the destination handset, press OFF/
INT, or place the handset back in the handset charger. Both screens display
Intercom ended.
• If you do not have any cordless handset registered to the telephone base,
Int requires two handsets displays when you press INT on the base.
You can cancel the intercom call before it is answered by pressing CANCEL
•
or INT.
• If the destination handset does not answer the intercom call within 100 seconds,
or if it is accessing the answering system, or is out of range, or is on a call, or is
in the directory or call log, the telephone base displays Unable to call.
Try again and then returns to idle mode.
, INT, or any dialing key (0-9, TONE or
28
Calling
HANDSET
Base
is calling
Intercom
12:21 3/19
pm
or
CANCEL