Using Centralized Telephone Programming - Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions

Using Centralized Telephone Programming

Use Centralized Telephone Programming to program features or store telephone
numbers for individual extensions from extension 10 or 11. Most features also
can be programmed on a system phone at the user's extension. Keep in mind
the following exceptions:
Automatic Line Selection and Line Ringing always must be
programmed using Centralized Telephone Programming.
If a user has a standard phone, Personal Speed Dial Numbers for the
extension can be programmed only by using Centralized Telephone
Programming.
If a user has a standard phone or a non-display system phone,
Extension Name Display for the extension can be programmed only by
using Centralized Telephone Programming.
During Centralized Telephone Programming, the display phone at extension 10
or 11 takes on the characteristics of the telephone being programmed, including
any System Programming settings and lines assigned to the phone. If you have
any 34-button phones in the system, you must use a 34-button display phone to
program since an18-button phone cannot be used to program a 34-button
phone. Also, if your system has both PARTNER-model and MLS-model phones,
it is recommended that you use a PARTNER-model display phone at the
programming extension.
To program a phone from extension 10 or 11, use the following procedure:
1. Place the Programming Overlay over the dialpad of the system display phone
at extension 10 or 11—see "The Programming Overlays" earlier in this
chapter for more information.
2. To start programming:
a. Press
PROGRAM EXTENSION 10
(If you are programming from extension 11, "11" displays instead of "10.")
b. Press
10 Enter Extension Name
This display is for the Extension Name Display feature. When you are
entering Centralized Telephone Programming mode, skip it by
moving on to Step 2c.
c. Press
SYSTEM PROGRAM
d. Press
CENTRAL TELEPHONE PROG
Extension:
2-24
Programming
f 0 0
. A display similar to the following appears:
s
. A display similar to the following appears:
s
again. The display reads:
c
. A display similar to the following appears: