Direct-Line Consoles - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
3 Lines/Trunks
Assigning Telephone Buttons
c.

Direct-Line Consoles

Use these instructions only if the system has one or more DLCs. Otherwise,
proceed to
each extension.
NOTE: NOTE: NOTE:
For more information on DLCs, see the Feature Reference .
The number of line, Direct Station Selector (DSS), and programmed feature
buttons assigned to a DLC depends on the type of telephone and the number of
lines/trunks connected to the system. The factory setting for DLCs is that, in
addition to an SA Voice and an SA Ring button or ICOM buttons, as many
lines/trunks as possible are assigned to each console. Each line/trunk appears on
a separate button, which means that the number of lines/trunks assigned is limited
to the number of buttons on the console (up to a maximum of 32 buttons on the
34-button analog DLC).
If a DSS is present, the system assigns a DSS button for each extension number
associated with an extension and special-feature buttons that are used by the
DLC operator for call-handling functions.
Figures3-6
analog DLC consoles. Refer to the appropriate figure as you select line/trunk
assignments for DLCs.
NOTE: NOTE: NOTE:
System Access buttons appear on DLCs in Hybrid/PBX mode. Intercom
buttons appear on DLCs in Key or Behind Switch mode.
Assign programmed Loudspeaker Paging buttons by selecting the
button and writing Page on it.
Chapter 4, ''Features'', to record feature assignments on the forms for
and 3-7 show initial line/trunk and feature assignments for MLX and
3
Issue 1
June 1997
Page 3-57