ECS X48T-A Manual page 46

40
* When enable the item CPU Over-clocking Func., the following picture will show.
CMOS Setup Utility - Copyright (C) 1985-2008 American Megatrends, Inc.
Manufacturer : Intel
Ratio Status: Unlocked (Min:06, Max:Unlimited)
Ratio Actual Value: 6
Ratio CMOS Setting
CPU Over-clocking Func. :
CPU Over-clocking Freq. :
PCIE Over-clocking Func. :
Auto Detect DIMM/PCI Clk
Spread Spectrum
CPU Voltage
Memory Voltage
1. The adjustment range of CPU Over-clocking Freq. depends on the
processor. And the system efficiency can be improved by adjusting the
item PCIE Over-clocking Func..
2. If the over-clocking fails, please turn off the system power. And then,
hold the PageUp key (similar to the Clear CMOS function) and turn on
the power, the BIOS will recover the safe default.
3. The improper use or the setting beyond the hardware specification will
result in the system instability.
Auto Detect DIMM/PCI Clk (Enabled)
When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.
Spread Spectrum (Disabled)
If you enable spread spectrum, it can significantly reduce the EMI (Electro-Magnetic
Interference) generated by the system.
Memory Current Type
This item shows the Memory Current Type.
DRAM Frequency (Auto)
This item shows the frequency of the DRAM in your computer.
Configure DRAM Timing by SPD (Enabled)
When this item is set to enable, the DDR timing is configured using SPD. SPD (Serial
Presence Detect) is located on the memory modules, BIOS reads information coded
in SPD during system boot up.
SPD eXtreme Memory Profile (Standard)
Use this item to select the SPD eXtreme Memory Profile. If the item is set to
Standard, the memory will work under the standard mode. If the item is set to Profile
1/2, the memory is capable to reach 1600 MHz.
Frequency/Voltage Control
6
Enabled
600
100
Enabled
Enabled
Normal
1.5V
: Move Enter : Select +/-/: Value F10: Save
F1:General Help
F9: Optimized Defaults
(7-20-7-7-8-60-4-4-4)
Using BIOS
Help item
ESC: Exit