Preserving Battery Life; Using The Optional Battery Eliminator - Fluke 744 User Manual

Preserving Battery Life

An optional
Auto Battery Save
calibrator off after a selected idle time. The default
setting for
Auto Battery Save
is , and you are using the optional Ni-
Battery Save On
Cd battery pack (Model BP7217), the
shows in the upper right corner of the display. The
setting is preserved after you turn off the power. Auto
Battery Save works the same when using the battery
eliminator. Turn on the
Auto Battery Save
follows:
1. Press .
2. Press to highlight
.
Save
3. Press or the
4. Press to highlight
5. To accept the timeout period shown on the
display, you can finish here. Press
Setup mode and do not go on to step 6.
feature turns the
is . When
Off Auto
symbol
feature as
following
Off Auto Battery
softkey.
Choices
, then press .
On
to exit
Done
Documenting Process Calibrator
6. To change the timeout period, press
highlight the timeout period following
.
Save Timeout
7. Press or the
8. Enter your choice of timeout period in minutes
(accepted range: 1 to 120 minutes).
9. Press the softkey.
Done
10. Press the softkey or
Done
mode.

Using the Optional Battery Eliminator

Caution
To avoid damage to the calibrator, use
only Fluke Model BE9005 Series Battery
Eliminator, available from your Fluke
representative.
Setting Up the Calibrator
to
Battery
softkey.
Choices
to exit Setup
23