Integrated Peripherals - ECS H55H-CM Manual

36

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
SATA Configuration
Onboard SATA Mode
Onboard Audio Function
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
Serial Port2 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
USB Function
Legacy USB Support
SATA Configuration (IDE)
Use this item to select the type of the build-in on-chip Serial ATA.
Onboard SATA Mode (Enhanced)
Use this item to enable or disable the build-in on-chip Serial ATA.
Onboard Audio Function (Enabled)
Use this item to enable or disable the onboard audio device.
Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1/2 Address (3F8/IRQ42F8/IRQ3)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Integrated Peripherals
IDE
Enhanced
Enabled
Enabled
Disabled
3F8/IRQ4
2F8/IRQ3
378
ECP
DMA3
IRQ7
Enabled
Enabled
: Move Enter : Select
+/-/: Value
F1: General Help
F9: Optimized Defaults
Using BIOS
Help Item
IDE
RAID
AHCI
F10: Save ESC: Exit