ECS H55H-CM Manual page 35

Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
1st/2nd/3rd Boot Device (Hard Drive/CD/DVD/Removable Drive)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
Hard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Hard Disk Drives
1st Drive
2nd Drive
: Move
F1: General Help
Press <Esc> to return to the Advanced Setup page.
Hard Disk Drives
MAXTOR STM3250310AS
Flash Disk
Enter : Select
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Using BIOS
Help Item
Specifies the boot
sequence from the
available devices.
33