Denon AVR-A100 Owner's Manual page 16

ENGLISH
2
Select "SW Test Start" and then press
Subwoofer level measurement begins.
During measuring, a "Testing ..." message is displayed.
The measured level appears on the level indicator after about
3 to 5 seconds.
AUDYSSEY AUTO SETUP
Subwoofer Level Matching
Please place the microphone at ear height at main
listening position, then push ENTER.
SW Test Start
dB
Next
Enter
Start measurement Output test tone from subwoofer
AUDYSSEY AUTO SETUP
Subwoofer Level Matching
Please adjust the level of your active subwoofer unit
so that the level Indicates approx. 75dB
Stop
Red
79.1dB
Enter
Change from red to blue when level matches
• If the measured level is outside the 72 to 78 dB range, the level
indicator is red.
ENTER
• When measuring stops, press
12
Remote control operation
buttons
3
Adjust the volume control on your subwoofer so that
ENTER .
the measured level is within the 72 to 78 dB range.
1 2 3 4 5 6
• If the measured level is within the 72 to 78 dB range, the level
Cancel
RETURN
indicator is blue.
4
When the measured level is within the 72 to 78 dB
range, press
5
1 2 3 4 5 6
Select "Next" and then press
Proceed to "Set up speakers (Audyssey ® Auto Setup),
STEP2 Detection & Measurement
.
When you use two subwoofers, adjust each subwoofer so that the
volume levels of Subwoofer 1 and Subwoofer 2 are appropriate for
your needs.
Move the cursor
(Up/Down/Left/Right)
Error messages
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Subwoofer Level Matching
Please adjust the level of your active subwoofer unit
so that the level Indicates approx. 75dB
Stop
Blue 73.9dB
Enter
Change from red to blue when level matches
ENTER .
ENTER .
" (vpage 9), 6 – w.
AUDYSSEY AUTO SETUP
Subwoofer Level Matching 1 2 3 4 5 6
After adjustment, push "Next".
SW Test Start
dB
Next
Enter Cancel
RETURN
Proceed to next measurement
Confi rm the setting
Parameter Check
This function enables you to check the measurement results and
equalizer characteristics after Audyssey Auto Setup.
1
Use to select "Parameter Check" and then
ui
ENTER
press or .
p
PARAMETER CHECK
Spkr Config Check
Distance Check
Ch. Level Check
Crossover Check
EQ Check
Restore
Check auto setup measurement results
2
Use to select the item you want to check, then
ui
ENTER
press or p .
Measurement results for each speaker are displayed.
Check the speaker confi guration.
Speaker Confi g Check
Check the distance.
Distance Check
Check the channel level.
Ch. Level Check
Check the crossover frequency.
Crossover Check
Check the equalizer.
EQ Check
• If "EQ Check" is selected, press ui to select equalizing curve
("Audyssey" or "Audyssey Flat") to be checked, and then press
ENTER
or p .
Use ui to switch the display between the different speakers.
3
Press RETURN .
The confi rmation screen reappears. Repeat steps 2.
Retrieving Audyssey Auto Setup settings
If you set "Restore" to "Yes", you can return to Audyssey Auto Setup
measurement result (value calculated at the start by MultEQ ® XT 32)
even when you have changed each setting manually.
Return to previous menu