Denon AVR-A100 Owner's Manual page 14

ENGLISH
STEP 4
Calculation
11
On the STEP3 screen, use
to select "Next → Calculation", and
ENTER
then press .
Measuring results are analyzed, and the
frequency response of each speaker in the
listening room is determined.
AUDYSSEY AUTO SETUP
STEP4 Calculation 1 2 3 4 5 6
Now calculating...Please wait.
27%
• Analysis takes several minutes to complete. The
time required for this analysis depends on the
number of speakers connected.
The more connected speakers there are, the
longer it takes to perform analysis.
10
Remote control operation
buttons
STEP 5
Check
12
Use ui to select the item you want
ui
to check, and then press
AUDYSSEY AUTO SETUP
STEP5 Check
Check processing results.
To proceed,press "Next".
Spkr Config Check
Distance Check
Ch.Level Check
Crossover Check
Next Store
Enter
RETURN
Select item to check
• Subwoofers may measure a greater reported
distance than the actual distance due to added
electrical delay common in subwoofers.
• If you want to check another item, press
RETURN
.
13
Use to select "Next → Store"
ui
and then press ENTER
NOTE
• If the result differs from the actual connection
status, or if "Caution!" is displayed, see "Error
messages" (vpage 11). Then carry out Audyssey
Auto Setup again.
• If the result still differs from the actual connection
status after remeasurement or the error message
still appears, it is possible that the speakers
are not connected properly. Turn this unit off,
check the speaker connections and repeat the
measurement process from the beginning.
• If you change speaker positions or orientation,
perform Audyssey Auto Setup again to fi nd the
optimal equalizer settings.
Move the cursor
(Up/Down/Left/Right)
STEP 6
Store
14
Select "Store" and then press
ENTER .
Save the measurement results.
AUDYSSEY AUTO SETUP
STEP6 Store
1 2 3 4 5 6
Press "Store" to store calculation results.
Store
Cancel
Apply and store measurement result
AUDYSSEY AUTO SETUP
STEP6 Store
Now storing... Please wait.
78%
.
• Saving the results requires about 20 seconds.
• If the measuring results are not to be saved,
RETURN
press . A message "Cancel auto
setup?" will be displayed. Press o then select
"Yes". All the measured Audyssey Auto Setup
data will be erased.
NOTE
During saving of measurement results, be sure
not to turn off the power.
Confi rm the setting
Set up speakers (Audyssey ® Auto Setup)
Finish
15
Unplug the setup microphone from
ENTER .
the unit's SETUP MIC jack.
16
Set Dynamic Volume ® .
1 2 3 4 5 6
AUDYSSEY AUTO SETUP
Finish
Storing complete.
Auto Setup is now finished.
Please unplug microphone.
Enter Cancel
Turn on Dynamic Volume?
RETURN
Yes
No
Turn Dynamic Volume on and exit Auto Setup
• For details of Dynamic Volume settings, see
page 90.
1 2 3 4 5 6
n When turning Dynamic Volume on
u
Use to select "Yes", and then press
• The unit automatically enters "Evening" mode.
n When turning Dynamic Volume off
Use i to select "No", and then press
NOTE
• After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
• After performing Audyssey Auto Setup with two
subwoofers, do not change the channel distances
and levels of both subwoofers.
Return to previous menu
1 2 3 4 5 6
Exit
ENTER
.
ENTER
.