Fiat Panda Owner's Handbook Manual page 25

Speed limit (Speed Beep)
With this function it is possible to set the
car speed limit (km/h or mph); when this
limit is exceeded the driver is immediate-
ly alerted (see section "Warning lights and
messages").
To set the speed limit, proceed as follows:
– briefly press button MODE, the display
will show the wording (Speed Beep);
– press button + or – to select speed lim-
it activation (On) or deactivation (Off);
– if the function has been activated (On),
press buttons + or – to select the re-
quired speed limit and then press MODE
to confirm.
Note The possible setting is between 30 and
200 km/h, or between 20 and 125 mph de-
pending on the unit set previously (see para-
graph "Setting the distance unit (Units)") de-
scribed later. Every press on button + / – in-
creases/decreases by 5 units. Keeping the
button + / – pressed obtains the automatic
fast increase or decrease. When you are
near the required setting complete adjust-
ment by single presses.
24
– briefly press button MODE en or press
the button for long to go back to the stan-
dard screen without storing settings.
To cancel the setting, proceed as follows:
– briefly press button MODE: (On) will
flash on the display;
– press button –: (Off) will flash on the dis-
play;
– briefly press button MODE to go back
to the menu screen or press the button
for long to go back to the standard screen
without storing settings.
Trip B On/Off (tripB data)
Through this option it is possible to acti-
vate (On) or deactivate (Off) the Trip B
(partial trip).
For further information see "Trip com-
puter".
For activation / deactivation, proceed as
follows:
– briefly press button MODE: (On) or
(Off) will flash on the display (according to
previous setting);
– press button + or – for setting;
– briefly press button MODE to go back
to the menu screen or press the button
for long to go back to the standard screen
without storing settings.
Set clock (Set time)
This function enables to set the clock
through two sub-menus: "Time" and
"Mode".
Proceed as follows:
– briefly press button MODE, the display
will show the two sub-menus "Time" and
"Mode";
– press button + or – to surf the two sub-
menus;
– select the required option and then
press button MODE briefly;
– if selecting "Time", briefly press button
MODE, "hours" will flash on the display;
– press button + or – for setting;
– briefly press button MODE, "minutes"
will flash on the display;
– press button + or – for setting;