Fiat Panda Owner's Handbook Manual page 110

Assembly diagram fig. 3
The tow hook structure must be fastened
in the points shown by letters "a-b-c-d"
using a total of 4 M10 screws.
The hook should be fastened to the body
avoiding any type of drilling and trimming
of the rear bumpers that remains visible
when the hook is removed.
IMPORTANT It is compulsory to fasten a
Standard tow ball
label (plainly visible) of suitable size and ma-
terial with the following wording:
MAX LOAD ON BALL 60 kg
After fitting, screw holes shall be sealed to
prevent an exhaust gas inlet.
fig. 3 F0G0225m
109